Alto-Shaam AR-7T

MN-39404 • Rev 0 • 05/18 • AR-7T Series Electric Rotisserie Manual 47
Cleaning and Preventative Maintenance
Daily Cleaning
Prior to automatic cleaning:
Cool oven to below 140°F.
Wipe all standing grease and debris from the bottom
of the oven. DO NOT wipe into the drain.
Remove, empty, and wash the drip tray with hot
soapy water.
Wipe the glass and outside of the oven
Wipe the door gasket
Install wheels and spits back into the oven
Start automatic cleaning cycle:
Check the liquid cleaner container to ensure there is
enough liquid cleaner available for the cleaning cycle.
Touch the cleaning icon on the home screen.
Select the desired wash cycle, and then touch the
check mark to begin the cleaning cycle.
Aer automatic cleaning cycle is complete:
Remove debris from the drain screen.
Check the grease level in the collection container.
Empty or replace container if needed.
Weekly Cleaning
Inspect door gaskets for tears.
Clean the outside of the oven with an approved
stainless steel cleaner.
Inspect grease collection hoses and containers for
damage.
Inspect liquid soap hose for kinks or cracks.
Ensure all lights are working.
Inspect the oven for any signs of grease or carbon
build up.
Inspect the oven for signs of scale build up.
Monthly Cleaning
Descale the oven using Alto-Shaam ScaleFree
descaling powder.
Inspect the drain piping for signs of leaks.
Preventative Maintenance Checklist
Annual inspection
Replace tubing from the drain box to the pumps.
Replace chemical pump tube if applicable.
Replace tubing from the pumps to the outlet fittings
on the oven.
Inspect drain piping for leaks.
Replace water line from solenoid to drain box.
Inspect the door gasket and replace if needed.
Inspect the heating elements.
Inspect the blower wheel.
Measure and Record the following incoming voltages
(as applicable):
L1-L2
L1-L3
L2-L3
L1-Ground
L2-Ground
L3-Ground
Measure and Record the amp readings for the following:
Convection motor
Spit motor
Heating Elements
Grease pump
Wash pump
Drain pump
Inspect the touch screen for damage.
Inspect the drip tray for cracks.
Tighten all electrical connections.
Clean and inspect the cooling fans as required.
Tighten door hinges.
Inspect grease collection hose and valve.
Inspect casters or legs, repair or replace if needed.
Inspect power cord for cracks or wear, replace if
needed.
To be done by operator To be done by an authorized service provider