Alto-Shaam AR-7T

MN-39404 • Rev 0 • 05/18 • AR-7T Series Electric Rotisserie Manual 39
Operation
How to load spits
Standard Spits
Each of the seven rotisserie spits includes two welded
prongs on the square end and one welded, ridged prong
on the tapered end. Insert the two-prong, square end
into the two holes indicated on the disk assembly drive
wheel in the drawing. Insert the tapered, ridged-prong
end into the top hole indicated on the opposite side
and maneuver until the ridge catches in the hole. Aer
placing one spit into the oven, rotate the rotisserie using
the jog button to load every other position. Continue
loading the spits one at a time. This is done to maintain
balance within the rotisserie.
Optional Spits and Baskets
When optional spits are used, insert the spits in the
drive wheel as indicated in the illustration.
When inserting the basket, put the smooth pin (1) end in
rst. When removing the basket, the machined pin (2)
comes out rst.
NOTE: When using a partial quantity of standard or
optional spits, space the spits evenly as possible
around the drive wheel to maintain balance and
even rotation.
A combination of standard, piercing, and basket
spits can be used at the same time but  in
every spit insertion position. The use of a spit in
every position will interfere with the free rotation
of the baskets. Using a combination of spits can
only be accomplished at signicantly reduced
rotisserie capacity.
1
2
Jog/Advance