1-24 American-Lincoln
MPV 60
1. Perform the Pre-Start checks found previously in this manual.
2. Turn the ignition switch to the “ON” position and place the engine speed switch to the high speed (2)
position.
3. Push and hold the glow plug switch for approximately 30 seconds. Under cold starting conditions, the
glow plug switch may be held longer but do not hold the switch for more than 60 seconds to prevent
damage to the glow plugs.
4. Turn the key switch to the start position and hold until engine starts. If the engine does not start
immediately, release the key switch after 15 seconds to prevent damage to the starter.
5. Release the glow plug switch when the engine starts.
WARNING
Do Not Turn The Steering Wheel Sharply When The Machine Is In Motion. The Sweeper Is Very Responsive To
Movement Of The Steering Wheel. Do Not Make Sudden Turns.
TO DRIVE SWEEPER FOR TRANSPORT
1. Ensure the main broom lever and the side broom lever are in “UP” position with all other sweeping
controls in the “OFF” position.
2. Release the parking brake.
3. Place the engine speed switch in the “1” or ”2" position.
4. Push forward on the foot pedal to start the sweeper moving.
5. Vary your foot pressure on the pedal to obtain the desired speed.
6. To stop, allow the foot pedal to return to the centered position. (Pedal will return to neutral when
pressure is released)
WARNING
Machines Can Ignite Flammable Materials And Vapors. Do Not Use With Or Near Flammable Items Such As:
Gasoline, Grain Dust, Solvents And Thinners.
TO SWEEP WITH THE MACHINE
1. Move the broom control lever to the “ON” position.
2. Lower the side and main broom to the floor. (The main broom control may be placed in either the
“FLOAT” or “SWEEP” position).
3. Press the Dust Control Switch to the “ON” position.
4. Push forward on directional control pedal to place machine in motion.
5. Vary foot pressure on the directional control pedal to obtain desired travel speed.
6. Read the “Helpful Hints for Sweeping” in this manual for tips on maximizing sweeping performance.
WARNING
Stop And Leave This Machine On A Level Surface. When You Stop The Machine, Put The Key Switch In The “OFF”
Position And Engage The Parking Brake.
TO STOP SWEEPING
1. Allow directional control pedal to return to neutral (centered) position. (Pedal will automatically return
to neutral when foot pressure is released.)
2. Depress the foot brake.
3. Press the Dust Control Switch to the “OFF” position..
4. Place the broom controls (Side and Main) in the “UP” position.
5. Move the Broom Control lever to the center “OFF” position.
6. Push engine speed switch to the “IDLE” position.
7. Set parking brake.
NOTE
To provide hydraulic power to the hopper controls, the broom control lever must be in the center “Neutral” Position
OPERATING INSTRUCTIONS
To Next Page
Loading...
