Altronic DE-3000 - View Channel Status Screens

DE-3000 IOI 7-17
All rights reserved © ALTRONIC, LLC 2017
20
11.0 VIEW CHANNEL STATUS SCREENS
11.1 Use the VIEW CHAN key to enter the view channels screens. Once in the VIEW
CHAN mode, the user can view any channel’s details.
• The first line will be the controller system status; TIMERS ACTIVE, RUN-
NING, FAULT AL12, or MANUAL STOP.
• The second line shows whether the input point is “ARMED” or “NOT
ARMED”. Class A points will always be armed; class B points become
armed only after their timers have timed out. Class C points arm when
cleared or when the timer times out.
• The third line shows the channel number and an analog value of that
input; if configured for that channel.
• The fourth line shows the user entered 20 character channel description.
Upon pressing the view channel key, channel 01 will be shown. The UNITS and
TENS keys allow the user to quickly navigate through the controller channels.
Use the
↑
UNITS or
↓
UNITS keys to increase or decrease the viewed channel by
one. Use the
→
TENS or
←
TENS keys to increase or decrease the viewed chan-
nel by ten. To exit the VIEW CHAN mode, press the ESC key. After five minutes
with no keypad activity, the display will revert to the current home screen.
FROM CURRENT HOME SCREEN
PRESS
VIEW
CHAN
TIMERS ACTIVE
STATUS TIMERS ACTIVE
SPEED 330 RPM
SUCTION 102.3 PSIA
DISCHARGE 200 PSIG
TO SEE CHANNEL 20 FROM CHANNEL 10
PRESS
→
TENS
TIMERS ACTIVE
STATUS TIMERS ACTIVE
NOT ARMED
CHAN 10
ENGINE OIL PRESSURE
TO SEE CHANNEL 21 FROM CHANNEL 20
PRESS
↑
UNITS
TIMERS ACTIVE
STATUS TIMERS ACTIVE
ARMED
CHAN 20
MANIFOLD PRESSURE
STATUS TIMERS ACTIVE
SPEED 330 RPM
SUCTION 102.3 PSIA
DISCHARGE 200 PSIG
STATUS TIMERS ACTIVE
NOT ARMED
CHAN 10
ENGINE OIL PRESSURE
STATUS TIMERS ACTIVE
ARMED
CHAN 20
MANIFOLD PRESSURE