DE-3000 IOI 7-17
All rights reserved © ALTRONIC, LLC 2017
24
PRESS
RESET
TIMERS ACTIVE
STATUS TIMERS ACTIVE
SPEED 1000 RPM
SUCTION 102.3 PSIA
DISCHARGE 200 PSIG
14.0
COOL-DOWN SCREEN
14.1 The cool-down mode enables the engine to enter a state before shutting down
where a number of sensors may normally fault low. Class B and C channels that
are configured for cool-down will not cause a fault during cool-down mode if
an input falls below the corresponding low safety setpoint (analog channels) or
switches out of its normal condition (discrete channels).
To enter cool-down mode, from the home screen, press the F2 key.
PRESS
F2
PRESS THE ENTER KEY
TO COOL-DOWN, OR
PRESS ESC TO EXIT
RUNNING
Pressing enter will start the cool-down timer and activate the cool-down chan-
nels. The status line on the home screen will display COOLDOWN xxx s; xxx
being the remaining cool-down time. Channels that are not programmed as cool-
down channels may still cause faults during this time.
PRESS
ENTER
STATUS COOLDOWN 1s
SPEED #1 1532 RPM
NOTUSED ---- ---
NOTUSED ---- ---
RUNNING
When the cool-down timer expires, the home screen status line will read FAULT
AL12 with the description, COOL-DOWN SHUTDOWN.
1
ST
FAULT
STATUS FAULT AL12
1st FAULT
COOL-DOWN SHUTDOWN
STATUS TIMERS ACTIVE
SPEED 1000 RPM
SUCTION 102.3 PSIA
DISCHARGE 200 PSIG
To Next Page
Loading...
