Amada UNIFLOW 4 REMOTE - Schedule Edit Keys; Heating Rate Key

CHAPTER 1: DESCRIPTION
UNIFLOW
®
4 PULSED HEAT CONTROL
1-8 990-908
Schedule Edit Keys
The Schedule Edit Keys allow you to edit the time and temperature parameters of the heat profile on the
graphic display. The BASE, RISE1, PREHEAT, RISE2, REFLOW, COOL1, POSTHEAT and COOL2 keys
are vertically aligned with the profile heating states as displayed on the graphic screen. When these keys
are repeatedly pressed, the input capability switches back and forth between time and temperature.
These keys are only active when the graphic screen is displayed.
HEATING RATE Key
The
HEATING RATE key brings up the MANUAL TUNING screen. This screen
allows you to go to the
SET COARSE HEATING RATE and SET FINE HEATING
RATE
heating rate capability to match the heat generating capability of the
thermode to minimize the temperature overshoot and undershoot. See Chapter 3,
Using Programming Functions for details.
<MANUAL TUNING >
1. Set Coarse Heating Rate : MEDIUM
2. Set Fine Heating Rate : 85%
Number Select an item, Graph / Data
<SET COARSE HEATING RATE >
1. Very Slow Medium
2. Slow
3. Medium
4. Fast
Number Select an item, Graph / Data
< SET FINE HEATING RATE >
SET FINE HEATING RATE : 85 %
0 10 20 30 40 50 60 70 80 90
◄► Adjust , ▲ Page, Graph / Data