CHAPTER 3: USING PROGRAMMING FUNCTIONS
UNIFLOW
®
4 PULSED HEAT CONTROL
990-908 3-15
You may initiate the HEAT cycle while
the DATA screen (rather than the GRAPH
screen) is displayed.
PROFILE NUMBER Keys
With the graphics screen on the display, these keys will increment/decrement the
heat profile number on the graphics screen. With the data screen on the display,
ressing either PROFILE NUMBER key returns the graphics screen to the display;
the keys will then increment/decrement the profile number on the screen. The
PROFILE NUMBER up/down keys are disabled when any screen other than the
graphic screen or data screen is on the display.
The number of possible heat profiles than can be stored ranges from 1 to 63.
COUNTERS Key
This key brings up the REFLOW COUNTERS screen.
Based on your settings for the Reflow Counters, the Control will display
messages when the thermode needs cleaning or replacement.
This screen provides a menu of selections
for setting the thermode cleaning and
thermode replacement counters, and
choosing responses to the counter
settings.
NOTE: With this and all other menu
screens on the display, you will not be
able to initiate the heating cycle.
< REFLOW COUNTERS >
1. TOTAL USAGE COUNTER : 0000004
2. GOOD REFLOW COUNTER : 0000004
3. CLEAN COUNTER : +999999
4. REPLACE COUNTER : +999999
Number Select an item, Graph / Data
Total Usage Counter
Press the 1 key to edit the total usage counter. With the numeric keys, you may select a number up to
9999999. The selected number is the total number of reflows completed since the counter was last
edited. When the counter reaches 9999999, it will change to 0000000 after the next process.
To Next Page
Loading...