Amada UNIFLOW 4 REMOTE - Graph Key; Graph Schedule Profile; Process Cycles

CHAPTER 3: USING PROGRAMMING FUNCTIONS
UNIFLOW
®
4 PULSED HEAT CONTROL
990-908 3-3
Graph Key
Pressing the
GRAPH key when any screen is displayed except for the Graph and
Schedule Setup Screens, will change the display to the GRAPH screen. Pressing
the
GRAPH key when the Graph or Schedule Setup Screens are displayed will
rotate the screen display through the
GRAPH and two Schedule Setup screens.
Graph Schedule Profile
The screen shown to the right displays
the default profile settings.
The profile temperature and time
p
arameters are edited while the GRAPH
screen is displayed.
For a complete description of the
information displayed on the GRAPH
screen, refer to Chapter 4, Operating
I
nstructions.
Process Cycles
The Control provides for up to eight programmable process cycles as shown in the following diagram: