Amada UNIFLOW 4 REMOTE - Reflow Setup; Set Idle Temperature On;Off; Set Safety Timer

CHAPTER 3: USING PROGRAMMING FUNCTIONS
UNIFLOW
®
4 PULSED HEAT CONTROL
990-908 3-27
REFLOW SETUP
With the SETUP MENU screen displayed,
p
ress the 3 key to bring up the REFLOW
SETUP
screen.
< SETUP MENU >
1. HARDWARE SETUP
2. COMMUNICATIONS
3. REFLOW SETUP
4. SYSTEM SECURITY
5. COPY PROFILE
6. SET TO DEFAULTS
7. LANGUAGE
8. I/O STATUS
Number Select an item, Graph / Data
SET IDLE TEMPERATURE ON/OFF
Press the
1 key to toggle between ON and
OFF. Selecting ON enables the Idle
Temperature value in the Profile. The
Idle temperature is set on the Schedule
Setup screen, Page 2 of 2. Selecting
ON forces the thermode temperature to
rise to the Idle temperature set in the
current Profile and to continuously stay
at the Idle temperature except during a
heating cycle. Selecting OFF turns off
the Idle temperature function no matter
< REFLOW TEMPERATURE SETUP >
1. IDLE TEMPERATURE IS : OFF
2. SET SAFETY TIMER : 10 SEC
3. SET RELEASE TIMER : 00 SEC
4. MAX TEMPERATURE LIMIT : 600 C
5. MAX AUX TEMPERATURE LIMIT : 600 C
6. MAX IDLE TEMPERATURE LIMIT : 300 C
7. DISPLAY AUX TEMP NUMBER : OFF
8. DISPLAY AUX TEMP LINE : OFF
Number Select,  Page, Graph / Data
what temperature value is set in the
current Profile.
SET SAFETY TIMER
Press the 2 key to bring up the SET
SAFETY TIMER SCREEN
. Use the safety
timer to abort the reflow cycle if
temperature has not risen to the REFLOW
temperature set point by the time set in
the safety timer. The safety timer starts
timing at the beginning of
RISE2. If the
time is exceeded, a
SAFETY TIME
EXCEEDED
alarm will be set.
< SET SAFETY TIMER >
SET SAFETY TIMER : 00
After edit Page to accept new value
Number Change, Adjust, Graph / Data
Use the number or keys to select a safety timer value of 00 to 99 seconds.