UNIFLOW
®
4 PULSED HEAT CONTROL
990-908 4-1
CHAPTER 4
OPERATING INSTRUCTIONS
Section I: Before You Start
Preparation
Before operating the Control:
You must be familiar with the principles of reflow soldering and/or heat sealing.
You must be familiar with the location and function of Controls and Indicators. For more
information, see Chapter 1, Description.
Verify that all equipment has been connected properly. See Chapter 2, Installation and Setup
and the instructions supplied with the Reflow Head.
You must be familiar with how to select and use the Control functions for your specific
applications. For more information, see Chapter 3, Using Programming Functions.
General Operator Safety
WARNING
To prevent blindness or eye injury, wear safety goggles at all times during reflow
soldering.
Be careful of moving parts. You can be injured by moving parts during the
reflow.
Do not wear loose clothing or jewelry around moving parts. They could get
caught and cause injury.
WARNING
People with pacemakers must stay away from the Control. When the Control is
operating, it generates a magnetic field, which adversely affects pacemakers.
People who use a pacemaker must
not approach the Control, or walk around the
soldering shop while the Control is operating, unless their medical doctor has
deemed it safe to do so.
To Next Page
Loading...