CHAPTER 2: INSTALLATION AND SETUP
UNIFLOW
®
4 PULSED HEAT CONTROL
2-2 990-908
2 KVA models: 48 pounds (21.8 kg) ● 4 KVA models: 60 pounds (27.2 kg)
● Install the Control in a well-ventilated area that is free from excessive dust, acids, corrosive
gases, salt and moisture.
● Allow sufficient clearance around both sides and back of the Control for power and signal
cabling runs, and to ensure adequate inflow and exhaust of air for the cooling system.
● Allow ample workspace around the Control so that it will not be jostled or struck while in use.
● The work surface must be level, stable, free from vibration, and capable of supporting the combined
weight of the total joining system.
● Make sure there are no sources of high-frequency energy close by.
● There can be strong magnetic fields around the cables connected between the thermode and the
Control. To avoid movement, secure the cables in cases of strong magnetic fields.
Utilities
Input power requirements for the Control are as listed below.
Control Model
Input Voltage, 50 or 60 Hz,
Single phase (Vrms)
Circuit Breaker
Rating (Amps)
1-298-02 120
15
1-298-02-XX & 1-299-02-XX, where XX is
any number
240
To Next Page
Loading...