Amada UNIFLOW 4 REMOTE - Force Fired, Air Actuated Head

To Next Page

To Previous Page

CHAPTER 2: INSTALLATION AND SETUP

UNIFLOW

4 PULSED HEAT CONTROL

990-908 2-11

4. Set the circuit breaker on the

rear panel of the Control to the

ON position. The default

graphic screen will display.

You will use this screen to enter

heating parameters.

Force Fired, Air Actuated Head

1. Adjust the head force adjustment knob to produce 5 units of force, as displayed on the force

indicator index.

2. Connect the head firing switch cable connector to the Control firing switch INITIATE cable

connector.

3. Connect the Foot Switch Cable to the

Foot Switch connector on the Control rear panel.