CHAPTER 4: OPERATING INSTRUCTIONS
UNIFLOW
®
4 PULSED HEAT CONTROL
4-10 990-908
Section IV: Process Cycle Parameters
Temperature Setting Ranges:
Idle ...................................................................................................... 25° to 300°C
Base ................................................................................................... 25° to 300°C
Preheat ............................................................................................... 60° to 500°C
Reflow (default) ................................................................................. 60° to 600°C
Reflow (extended mode operation) ................................................... 60° to 999°C
Cool1 ................................................................................................. 25° to 300°C
Postheat .............................................................................................. 25° to 600°C
Cool2 ................................................................................................. 25° to 300°C
Maximum Temperature ................................................................... 300° to 999°C
Time Setting Ranges:
Base ............................................................................................ 0 to 99.9 seconds
Rise1 .......................................................................................... 0.0 to 9.9 seconds
Preheat ........................................................................................ 0 to 99.9 seconds
Rise2 .......................................................................................... 0.0 to 9.9 seconds
Reflow ..................................................................................... 0.1 to 99.9 seconds
Postheat ....................................................................................... 0 to 99.9 seconds
Process Cycle Steps (No Postheat)
Process Cycle Steps (With Postheat)
To Next Page
Loading...