CHAPTER 3: USING PROGRAMMING FUNCTIONS
UNIFLOW
®
4 PULSED HEAT CONTROL
3-2 990-908
In general, there are three kinds of instructions on the bottom line of the screen. For and example, refer
to the Schedule Setup, Page 1 of 5 screen:
The instruction on the left side of the screen briefly describes the appropriate response for the options on
the current screen. For example, to select the PREHT PEAK HI TEMP LIMIT function on this screen, you
would press the 4 key.
● The next instruction is usually a page up or page down instruction. For example, press the
key to scroll to the
SCHEDULE SETUP, Page 2 of 5 screen. Press the key to step backwards
through the screen sequence.
● The instruction on the right is an “escape” function, returning the Control to its
Ready mode in
the graphics or data display screens. For example, pressing the GRAPH key to returns you to
the graphic display.
Run Mode
Press the GRAPH or DATA key to enter the RUN mode. With the GRAPH screen on the display:
The Control can run processes when
either the GRAPH or DATA screens are
displayed. These screens display actual
temperature, process cycle state, process
results, and status and error messages.
Setup Mode
Press the SETUP key to enter the setup
mode. In the setup mode, the display
resents system setup options for you to
select.
For details, refer to SETUP Key later in
this chapter.
< SETUP MENU >
1. HARDWARE SETUP
2. COMMUNICATIONS
3. REFLOW SETUP
4. SYSTEM SECURITY
5. COPY PROFILE
6. SET TO DEFAULTS
7. LANGUAGE
8. I/O STATUS
Number Select an item, Graph / Data
To Next Page
Loading...