To Next PageTo Next Page
Need help?Do you have a question about the Amana LE8217*2 and is the answer not in the manual?
Steps for removing and installing the motor mounting bracket to the motor.
Procedures for connecting neutral wires and checking power cord grounding.
Steps for removing and servicing the control hood, end caps, and graphics panel.
Servicing door panels, seals, and reversing the door swing.
Details on servicing gas burner system components like igniter and flame sensor.
Procedures for removing and servicing the motor and exhaust assembly.
Instructions for removing the cabinet top and front bulkhead assembly.
Procedures for servicing the terminal block or power cord connections.
Instructions for adjusting the dryer's leveling legs for stability.
How to adjust the burner flame for optimal operation in gas models.
Procedures for testing the drive motor's function and windings.
Testing the electrical circuit supplying power to the ignition system.
Procedures for testing the resistance of gas valve coils.
Testing the timer's advance function and contact points.
Common causes and solutions for a dryer motor that fails to run.
Diagnosing issues where the dryer fails to heat or the burner won't ignite.
Identifying causes and solutions for clothes not drying properly.
Diagnosing and resolving issues where clothes are excessively hot.
Diagram showing the internal wiring of the dryer motor switch.
Details on electrical service, voltage, and wiring for electronic control models.
Guidelines for proper grounding and wiring connections for electronic models.
Explains the different dryer operation modes like Automatic and Time Dry.
Steps for replacing the electronic control board in electromechanical models.
Troubleshooting steps when the timer fails to advance during operation.
Provides wiring diagrams specific to various dryer models.
General
