a WARNING
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the dryer before servicing.
• Close gas shut-off valve to gas dryer before servicing.
• Never start the dryer with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the dryer is properly grounded.
W001
19
RS3200001 (502992R3)
Figure 20
17.DOOR STRIKE
a. Open loading door.
b. Remove screw holding door strike and
bracket to loading door, Figure 19, and
remove strike and bracket.
NOTE: You may have to loosen the two screws
on end of door to allow for striker and bracket
removal.
18.DOOR SEAL
a. Open loading door.
b. Grasp either end of door seal at bottom of
door and remove seal from tabs on inner door
panel by gently pulling on the seal, Figure 20.
NOTE: When replacing seal, be sure seal is not
stretched or distorted and the groove in the seal
is installed on each tab on inner door panel,
Figure 20, and the split in the seal is at the
bottom of the door.
To Next Page
Loading...
