Amana LE8217*2 - Terminal Block and Power Cord Grounding

a WARNING
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the dryer before servicing.
• Close gas shut-off valve to gas dryer before servicing.
• Never start the dryer with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the dryer is properly grounded.
W001
7
RS3200001 (502992R3)
Rev. 3
Figure 3
3. POWER CORD TO REAR BULKHEAD AND FROM REAR BULKHEAD TO CONTROL HOUSING. WALL
RECEPTACLE POLARITY CHECK (Gas Models Only — Figure 3).
2. NEUTRAL AT TERMINAL BLOCK TO REAR BULKHEAD AND FROM REAR BULKHEAD TO
CONTROL HOUSING (Electric Models Only — Figure 2).
Figure 2
Canadian Models
U.S. Models