a WARNING
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the dryer before servicing.
• Close gas shut-off valve to gas dryer before servicing.
• Never start the dryer with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the dryer is properly grounded.
W001
46
RS3200001 (502992R3)
SECTION III
Adjustments
46. LEVELING LEGS (Figure 47)
NOTE: Dryer should be installed on a solid and
level floor.
a. Place dryer in position, adjust the legs until
dryer is level.
NOTE: Legs can be adjusted outside the dryer
by using a 1-1/4 inch size wrench, or from inside
the dryer (with lower front access panel
removed) by using a 1/4 inch drive ratchet with
extension.
b. Keep dryer as close to the floor as possible.
All four legs must rest firmly on the floor so
weight of the dryer is evenly distributed. The
dryer MUST NOT rock.
IMPORTANT: DO NOT move the dryer at any
time unless the dryer is completely assembled.
DO NOT slide the dryer across the floor once the
leveling legs have been extended as the legs
and base could become damaged.
a WARNING
To reduce the risk of electrical shock,
fire, explosion, serious injury or death,
disconnect electric power to the dryer
before servicing.
Figure 47
To Next Page
Loading...
