a WARNING
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the dryer before servicing.
• Close gas shut-off valve to gas dryer before servicing.
• Never start the dryer with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the dryer is properly grounded.
W001
3
RS3200001 (502992R3)
66. Heating Assembly Does Not Heat
or Burner Does Not Ignite ...............................62
67. Igniter Does Not Glow .....................................63
68. Burner Ignites and Goes Out Repeatedly .......63
69. Igniter Glows But Burner Does Not Ignite.......63
70. Heater Assembly or Burner Shuts
Off Prematurely ................................................64
71. Heater Assembly or Burner Repeatedly
Cycles Off On Limit Thermostat ......................64
72. Heater Assembly or Burner Does Not
Shut Off ............................................................65
73. Clothes Do Not Dry..........................................65
74. Timer Does Not Advance in
Automatic Cycle ...............................................66
75. Clothes Are Too Hot When Removed
From Dryer .......................................................66
SECTION VI — Internal Wiring of Dryer Motor
Switch ..............................................................67
SECTION VII — Service Procedures Unique
to the Electronic Control
Model Dryers
76. Electrical Service .............................................68
77. Grounding Instructions .....................................74
78. Failure Symptoms ............................................75
79. Blown Fuse or Tripped Circuit Breaker ...........77
80. Control Will Not Wake Up (No LED’s Light)
After SELECT CYCLE Pad is Pressed ...........78
81. Control Wakes Up (When SELECT CYCLE
Pad is Pressed (But Motor Does Not
Start) .................................................................79
82. Heater Does Not Turn On or No Heat ............80
83. Improper Drying Temperature
or Dry Times ....................................................81
84. “oP” Appears in Time Display .........................83
85. “SH” Appears in Time Display .........................84
86. Dryer Goes Into Cool-Down in About
Five Minutes and Load is Not Dry...................85
87. Control Replacement .......................................86
Electronic Control Board Replacement Report ......87
SECTION VIII — Service Procedures Unique to
the Electromechanical Dryers with Moisture
Sensor
88. Dryer Operation................................................88
89. Automatic Cycles .............................................88
90. No Heat ............................................................88
91. Time Dry ...........................................................88
92. Control Replacement .......................................89
93. Timer Contract Points ......................................90
94. Temp/Dryness Control Resistance Chart........91
95. Timer Does Not Advance ................................92
96. Heater Does Not Turn On or No Heat ............93
97. Heater Assembly or Burner
Shuts Off Prematurely .....................................94
98. Clothes are Too Hot When
Removed From Dryer ......................................95
SECTION IX — Wiring Diagrams .........................96
To Next Page
Loading...
