a WARNING
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the dryer before servicing.
• Close gas shut-off valve to gas dryer before servicing.
• Never start the dryer with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the dryer is properly grounded.
W001
42
RS3200001 (502992R3)
Figure 46
b. Power Cord:
(1)Remove access plate on rear of cabinet.
(2)Remove strain relief.
(3)Remove screw holding power cord ground
wire to rear bulkhead, Figure 46.
NOTE: Reinstall screw and ground wires into
same hole in bulkhead when reinstalling power
cord.
(4)Disconnect molex plug and remove power
cord from rear of dryer cabinet.
To Next Page
Loading...
