3-36 | Model 931S / Model 932S UV Analyzers
Figure 3-15.
Temperature Control
dialog box.
From the Status tab, check for alarms in the HC Scode and MC
Scode alarm lists. Temperature-related alarms should correct
themselves after the analyzer has warmed up to normal operating
temperature.
After all alarms have cleared, recheck the temperature of each
zone. Compare the current temperatures to their respective
Setpoint values and their start-up values. Normal operating tem-
peratures are values that are within 5 % of their Setpoint values.
Figure 3-16.
Status tab (Model
932S).
To Next Page
Loading...
