Ametek EM TEST compact NX - Starting a Test; The Test Run; Info: Button Status Indicators

AMETEK CTS Quick start guide - Conducted
1.00 30 / 50
7.10. 8. Starting a test
7.11. 9. The test run
7.12. Info: Button Status indicators
1. Press “TEST ON” to enable High
voltage and power to the EUT
2. Press “START/PAUSE” to start a test.
3. Long press “START/PAUSE” for
continuous test.
1. Press “START/PAUSE” to pause or
press “STOP” to stop a test.
2. Press “START/PAUSE” to continue or
start a test.
3. After Stop press “BACK” to return to
Menu or tap the ←.
White: HV and EUT Power Disabled
Yellow: HV and EUT Power Enabled
Green: Ready or Paused
Orange: Testing
Red: Testing
Red blinking: Error