AMETEK CTS Quick start guide - Conducted
1.00 6 / 50
1. Safety
1.1. Safety Aspects
Observe all precautions to assure your personal safety. The generators comply with Installation Category II (excess voltage
section).
Read the user / operation manual carefully. Pay special attention to safety and operation details!
1.2. Safety and warning label on the device
Please take note of the following explanations of the symbols used in order to achieve the optimum benefit from this manual
and to ensure safety during operation of the equipment.
This symbol warns of a potential risk of shock hazard. The symbol on an instrument shows that
that it can source 1000 volt or more, including the combined effect of normal and common
mode voltages. Use standard safety precautions to avoid personal contact with these voltages.
This symbol indicates where a caution is required. Refer to the operating instructions located in
the manual in order to protect against personal injury or damage the equipment.
GROUND Indicates protective Ground Terminal
CAUTION
The CAUTION symbol indicates a potential hazard. It calls attention to a procedure, practice or
condition which, if not followed, could possibly cause damage to equipment. Such damage may
invalidate the warranty. If a CAUTION is indicated, do not proceed until its conditions are fully
understood and met.
WARNING
The WARNING symbol indicates a potential hazard. It calls attention to a procedure, practice
or condition which, if not followed, could possibly cause bodily injured or death. If a WARNING
is indicated, do not proceed until its conditions are fully understood and met.
Power Supply
The equipment is intended to operate with a power supply not to exceed 250 volts between phase and neutral or between
phase and ground. A proper ground connection through the ground connector of the power cord is essential for safe
operation.
Grounding the Generators
The generators are grounded through the power cord. To avoid electric shock, plug the power cord into a properly installed
receptacle which was tested by a qualified electrician. Have the test performed before connecting equipment.
Without the protective ground connection, all parts of the generators are potential electric shock hazards. This may include
components which appear to be insulated. The equipment MUST NOT BE USED if this protection is altered.
Use the Proper Power Cord
Use only power cords and connector specified for your product. Use only power cords in good condition.
Use Proper Fuses
To avoid fire hazard, use only fuses as specified in the parts listing for your product - matching type, voltage and current
rating.
Do Not Remove Covers or Panels
To avoid personal injury, do not operate the generators without panels and covers.
Do Not Operate in an Explosive Environment
Electric Overload
Never apply power to a connector which is not specified for that particular voltage/current.
To Next Page
Loading...
Need help?
General
