Ametek Land Cyclops L Series

Portable Thermometers
User Guide
Cyclops L
7 - 12
7.6.4 Trigger Mode
Triggeroperationdeterminesthewayinwhichthethermometeroperates,and
whathappenstothereadingstakenbytheinstrument.Thearevetrigger
operations:Classic(i),Burst(ii),Latched(iii),Route(iv)andOperator
Emissivity(v).SeeSection8-TriggerOperation.Thedefaulttriggeroperation
isClassic.
(i) (ii) (iii) (iv)
7.6.5 Alarms
Allowsyoutospecifyalarmvaluesforthetargetbeingmeasured.Thefunction
hasthreesub-options:High Alarm(i),Low Alarm(ii)andAlarm O(iii).
Whenhighorlowalarmsareselected,avaluesettingscreenappears.Usethe
and keystoenterthealarmtriggertemperature.Thedefaultsettingfor
HighandLowalarmisthethermometermid-rangevalue.
Whenanalarmthresholdvaluepassed,avisualindicationisprovidedonthe
sidedisplay(
=abovehighalarmvalue: =belowlowalarmvalue).An
audiblewarning(fastbeep)isalsoprovidedifthesoundersettingin‘On’.
(i) (ii) (iii)
7.6.6 Averager time constant (not applicable to Cyclops 055L models)
Theaveragertimeconstantfunctionallowsyoutosettherateofaveragingof
thetemperaturevaluestaken.Therearethreeoptions:Fast(i),Mid(ii)and
Slow(iii).ThedefaultsettingisMid.
(i) (ii) (iii)
7.6.7 Units
Select°C,°F,K(Kelvin)or°R(Rankine).Note:Ifthehighresolutiondisplay
isselected(7.6.12),only°Cisavailable.
(i) (ii) (iii) (iv)
7.6.3b Deleting previous reading in Record Mode
IfRecordmodeisenabled,the‘Delete1’iconisavailableastherstmenu
item.Thisallowsquickdeletionofthelaststoredreading.
(v)