Ametek Sorensen SG Series - Page 147

M550129-03 Rev L Index-1
INDEX
A
Accuracy
programming, Ethernet, 4-4
readback, Ethernet, 4-5
Analog Program Adjustment, 7-11
atures and Functions
Ethernet, 4-2
C
CALibrate, 6-27
Calibration
Current Measurement/Readback Calibration,
7-9
Setup for Calibration, 7-2
Voltage Programming Calibration, 7-3
Warning, 7-1
Calibration Procedrues
Current Programming Gain/Offset and
Measurement Readback, Ethernet, GPIB,
7-9
Introduction, 7-1
Voltage Programming, Ethernet, 7-3
Calibration Procedures, 7-1
Analog Program Adjustment, 7-11
Current Programming, Ethernet, 7-7
Setup, 7-2
Voltage Program Gain/Offset and
Measurement Readback, Ethernet, GPIB,
7-5
CALIBRATION SCPI Command Reference, 6-
29
CalibrationProcedrues
Overvoltage Protection Programming
Calibration, Ethernet, GPIB, 7-6
Configuration
Ethernet/Lan, 4-3
RS232 Setup Procedure, 3-3
Setup Procedure, Ethernet, 5-3
Configurations
IEEE 488.2 GPIB Setup Procedures, 3-4
Setup Procedure, DHCP, 5-4
Conventions
[ ], 6-9
E
Error/Event Queue, 6-5
SCPI Error Codes, 6-5
Ethernet Web Pages, Overview, 5-14
Examples, Using SCPI Commands, 6-42
Hardware Trigger, 6-44
OVP Setup, 6-42
Power On INIT, 6-45
Ramp I, 6-44
Ramp V, 6-44
Ramp V, 2, 6-45
Sequences, 6-46
Trigger, 6-43
VI Mode, 6-42
External User Control Signal Connector
FAULT output signal, 5-11
FOLDBACK output signal, 5-11
ISOLATION output signal, 5-11
POLARITY output signal, 5-11
SENSE output signal, 5-11
TRIGGER OUT output signal, 5-11
External User Control Signal Connector