Ametek Sorensen XTR - Page 17

Contents
M370430-01 Rev B xv
FIGURE 4-2 INSERTING SCREWDRIVER INTO SPRING TERMINAL BLOCK ................... 4-7
FIGURE 4-3 APG AND DC OUTPUT CONNECTOR ........................................................... 4-7
FIGURE 4-4 PROGRAMMING OUTPUT VOLTAGE USING AN EXTERNAL VOLTAGE
SOURCE ......................................................................................................... 4-9
FIGURE 4-5 PROGRAMMING OUTPUT CURRENT USING AN EXTERNAL VOLTAGE
SOURCE ......................................................................................................... 4-9
FIGURE 4-6 PROGRAMMING OUTPUT VOLTAGE USING AN EXTERNAL RESISTOR .... 4-14
FIGURE 4-7 PROGRAMMING OUTPUT CURRENT USING AN EXTERNAL RESISTOR .... 4-14
FIGURE 4-8 VOLTAGE READBACK USING APG CONNECTOR J1 ................................ 4-19
FIGURE 4-9 CURRENT READBACK USING APG CONNECTOR J1 ................................ 4-19
FIGURE 4-10 AUX OUTPUT AND ISOL CONNECTOR PINOUT ....................................... 4-20
FIGURE 4-11 PROGRAMMING OUTPUT VOLTAGE USING AN ISOLATED EXTERNAL
VOLTAGE SOURCE ..................................................................................... 4-22
FIGURE 4-12 PROGRAMMING OUTPUT CURRENT USING AN ISOLATED EXTERNAL
VOLTAGE SOURCE ..................................................................................... 4-22
FIGURE 4-13 PROGRAMMING OUTPUT VOLTAGE USING AN ISOLATED EXTERNAL
RESISTOR .................................................................................................... 4-27
FIGURE 4-14 PROGRAMMING OUTPUT CURRENT USING AN ISOLATED EXTERNAL
RESISTOR .................................................................................................... 4-27
FIGURE 4-15 ISOLATED VOLTAGE MONITORING .......................................................... 4-32
FIGURE 4-16 ISOLATED CURRENT MONITORING........................................................... 4-32
FIGURE 5-1 REMOTE CONTROL CONNECTORS .............................................................. 5-3
FIGURE 5-2 RS-232 COMMUNICATION CABLE WITH DB-9 PINOUT ............................. 5-5
FIGURE 5-3 DB-25 PINOUT .............................................................................................. 5-5
FIGURE 5-4 RS-232 COMMUNICATION CABLE WITH DB-25 PINOUT ........................... 5-6
FIGURE 5-5 RS-485 COMMUNICATION CABLE WITH DB-9 ........................................... 5-7
FIGURE 5-6 RS-485 COMMUNICATION CABLE FROM MASTER TO SLAVE UNIT ......... 5-8
FIGURE 5-7 FOUND NEW HARDWARE WIZARD ........................................................... 5-10
FIGURE 5-8 INSTALL HARDWARE DEVICE DRIVERS ................................................... 5-10
FIGURE 5-9 COMPLETING THE NEW HARDWARE WIZARD ......................................... 5-11
FIGURE 5-10 DEVICE MANAGER ..................................................................................... 5-12
FIGURE 5-11 COMMUNICATIONS PORT (COM1) PROPERTIES ..................................... 5-13
FIGURE 5-12 COMPLETING THE NEW HARDWARE WIZARD .......................................... 5-13
FIGURE 5-13 SCANNING FOR INSTRUMENTS ................................................................... 5-17
FIGURE 5-14 INSTRUMENT PROPERTIES ........................................................................ 5-18
FIGURE 5-15 MULTI POWER SUPPLY CONNECTION TO RS-485 BUS ............................ 5-19
FIGURE 5-16 USB SETTINGS ............................................................................................ 5-22
FIGURE 5-17 ASCII SETUP .............................................................................................. 5-23
FIGURE 5-18 SCPI STATUS REPORTING MODEL ........................................................... 5-30