Table A-3 SCPI Commands for Output Control
[[:]]SOURce[<channel>]]:COMBine:CSHare
[: MODE]
Set the unit to operate in the
current share controller or
slave mode. If only a single
unit is being used it should be
set to controller.
Set
(Immediate)
Current Set
point
[[:]SOURce[<channel>]]:CURRent[:LEVel]
[:IMMediate][:AMPLitude]
Set current set point
(immediate)
?|<Current Set
Point>|MAXimum|
MINimum
Set Constant
Power
1
Set
point
Set constant power set point
(immediate)
Set constant power mode
(Enable/Disable)
Set
(Immediate)
Voltage Set
point
[[:]SOURce[<channel>]]:VOLTage[:LEVel]
[:IMMediate][:AMPLitude]
Change voltage set point
(immediate)
?|<Voltage Set
Point>|MAXimum|
MINimum
Set Over
Voltage
Protection
Level
[[:]SOURce[<channel>]]:VOLTage:PROTect
ion[:OVERvoltage][:LEVel]
Set the over voltage
protection level.
?|<OVP Set
Point>|MAXimum|
MINimum
Set Under
Voltage
Protection
Level
[[:]SOURce[<channel>]]:VOLTage:PROTect
ion:UNDer[:LEVel]
Set the under voltage
protection level.
?|<UVP Set
Point>|MAXimum|
MINimum
1
version 2.21 and higher