Menu Option Charts | B-3
CALIBRATE KEY
Menu Options
Functions/Options
Initiate Cal/Initiate Verify
Start an automatic, remote, or manual calibration
or verify
Cal/Verify Data
View latest calibration and verify data.
- Cal data
- Verify data
Cal Gas Values Enter calibration gas values.
Inject Cal Gas
Set pressure and ow to RCU gases without
performing a calibration.
Set Cal Timers
(applies only for auto cal operations with
RCU, except for setting time and date)
Set control unit time/date.
Enable or disable auto cal cycles.
Set cal gas times for auto cal/verify operations.
Dene recovery durations after a cal/verify.
Set K Factor (not used on WDG-IV Series) Enter Value
Sensitivity
View the Sensitivity (Slope) determined dur-
ing calibration for the combustibles detector in
mV/1000 PPM.
Table B-5. Calibrate Key menu.
To Next Page
Loading...
