Ammann ARX 40 - Lifting at the 4-Point Lifting Eyes; Securing the Roller on the Transporter

Transport 131
1208531 | 03.07.2012
12.1.2 Lifting at the 4-point lifting eyes
With the 4-point lifting eyes, lift the roller with suitable tools using the four lifting eyes
integrated in the wheel suspension.
1 Bring the joint protection into place.
2 Lift the roller vertically with suitable hoisting tackle.
2.1 Always use all four lifting eyes integrated in the wheel suspension.
The 4-point lifting eyes are designed for a WLL of 5 tons (Working Load Limit).
Fig. 12-2 4-point lifting eye
NOTE The lifting devices (steel ropes, etc.) must be at least 1,800mm long.
NOTE The roller will weight less if the water tanks are drained before transporting.
12.1.3 Securing the roller on the transporter
1 Bring the joint protection into place.
2 Attach the lashing straps to the lashing rings on the roller and on the truck
2.1 Lashing method: Direct lashing/diagonal lashing as shown in photo
2.2 Use a lashing strap with a permissible tensile force of LC = 2,500 daN
The lashing rings on the roller are designed for a permissible tensile force of
2,500 daN.
DANGER
Danger to life through suspended loads!
• Persons should not linger beneath suspended loads!
!