Operation 61
1208531 | 03.07.2012
NOTE The control lamps for engine oil pressure, charging, hydraulic brake re-
lease/supply pressure light up when the ignition is switched on. They extingu-
ish once the engine is running.
Pre-heating If the outside temperature is below 0°C:
1 Turn the ignition key to position II
1.1 hold it in this position for 15sec.
2 Turn the ignition key further to position III.
NOTE When starting and driving the roller from cold, with cold hydraulic oil, braking
distances are longer than when the oil has reached normal working tempera-
ture.
7.5 Driving and braking
7.5.1 Setting the speed
Speed adjusting lever
The roller has one operating speed.
1a Idling speed: Move the speed adjusting lever downward.
1b Operating speed: Move the speed adjusting lever towards the right at the top.
2 Check whether the steering is working.
7.5.2 Driving
Driving forwards 1 Push the operating lever forward slowly.
The roller moves forward.
Slowing down 1 Slowly pull the operating lever into neutral position.
The roller is automatically hydrostatically braked.
To Next Page
Loading...
