136 ARX 4
1208531 | 03.07.2012
13.1 Introduction
The roller must be disposed of properly; ask your authorized dealer.
13.2 Removal and depressurization of the gas struts
In case of disposal, pressurized gas struts must be depressurized according to the
following regulations:
1 Fasten the pressurized tube between two prismatic jaws without deforming it
and in such a way that the dimension X is at least 25mm (see below).
2 To depressurize:
2a Slowly cut the pressurized tube open at the points indicated using a handsaw
or,
2b Drill a hole in the tube using a drill with about a 3 mm diameter.
CAUTION
Environmental hazard through operating materials!
• Do not allow any liquids get into drains, soil or the environment.
WARNING
Eye injury!
Because of the high internal pressure, chips and oil can spat-
ter from the site of sawing or drilling.
• Wear eye and face protection.
• Cover the site of the saw cut.
CAUTION
Environmental hazard through operating materials!
Gas struts are filled with oil.
• Do not allow any liquids get into drains, soil or the environment.
To Next Page
Loading...
