84 ARX 4
1208531 | 03.07.2012
9.1.1 Battery safety instructions
NOTE Doing welding work on the roller when the battery in installed can damage the
electrical controls!
• Always remove the battery completely before performing welding work on
the roller.
NOTE Always replace the battery with a service-free battery. If you are using a battery
that requires maintenance, always observe the safety instructions in the batte-
ry manual.
9.2 General information about maintenance
NOTE Not all maintenance tasks are listed in these operating and maintenance inst-
ructions. We would also like to point out the separate manual for the Yanmar
engine.
● When carrying out maintenance work always observe the applicable safety regu-
lations in the 3 Safety information, Page 27 section.
● Maintenance work and inspections must be performed according to the following
maintenance tables in order to guarantee reliable roller operation.
● Remove all dirt before taking off any covers, plugs, measuring rods, etc. to inspect
or top up engine oil, hydraulic oil, diesel or other liquids.
● Any parts that do not pass the following inspections must be replaced immedia-
tely.
The protective devices must be correctly refitted after every service.
DANGER
Risk of serious injury through leaking battery acid!
The sulfuric acid in the battery is poisonous and so strong it
can burn holes in clothes and dissolve skin. If it gets into eyes
it can lead to blindness.
• Protect the battery from fire, flames and sparks.
• Protect the battery from mechanical damage.
DANGER
Risk of explosion when charging battery!
• Never check the battery charge level with a metal object. Use
a voltmeter or the battery's charge indicator.
• When disconnecting the battery always disconnect the negati-
ve terminal first (-).
• Connect the positive terminal (+) first when reconnecting.
To Next Page
Loading...
