EasyManua.ls Logo

Ammann ARX 40 - Reversing Alarm; Battery Cut-Off Switch; Battery Cut-Off Switch on; off

Ammann ARX 40
152 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
76 ARX 4
1208531 | 03.07.2012
8.6 Reversing alarm
The reverse alarm is active as soon as the roller drives backward. The alarm stays
on until the roller starts to drive forward or comes to a standstill.
97dB +/- 4dB to SAE J 994, Oct. 03
8.7 Battery cut-off switch
The battery cut-off switch interrupts the power supply from the battery to the roller.
Switch off the battery cut-off switch if the roller is not in operation for longer than two
days.
NOTE Always disconnect the power supply when working on the electrical system.
8.7.1 Battery cut-off switch on / off
The battery cut-off switch is located under the cowling above the battery.
Switching on
the power
1 Turn the red key of the battery cut-off switch left to horizontal position.
If fitted, the roller is now supplied by the starter battery.
Fig. 8-7 Switching on the power
Switching off
the power
1 Turn the red key of the battery cut-off switch down to vertical position.
This interrupts the power supply.
DANGER
Rollover hazard when driving the roller!
Get out of the danger zone immediately!
No persons may stand in front of or behind the roller while it is
in operation.
!

Table of Contents

Related product manuals