Maintenance 107
1208531 | 03.07.2012
Fig. 9-30 Air intake
9.13.5 Seat contact and emergency stop
1 Put the operating lever into the neutral position.
2 Sit on the driver’s seat.
3 Start the engine.
Brake light (P)
3.1 The brake light (P) must extinguish at once.
4 Leave the seat.
4.1 After 0.7sec., the brake light must light.
5 Switch off the engine.
NOTE The emergency stop control lamp only lights when the emergency stop is
pressed.
NOTE The control lamp for the emergency stop circuit, operating lever neutral posi-
tion and seat contact must extinguish after 2seconds for delayed seat contact.
9.13.6 Brakes (brake test)
Parking brake
switch
If the roller moves in spite of the actuated parking brake switch, you must perform the
brake test.
1 Remove the brake hose from the front roller drum drive motor.
2 Seal the open hose end so that it can be pressurized.
To Next Page
Loading...
