Mi Series Audio Controllers
2
Mi Series Audio Controllers
Product Specifications
The following table provides technical specifications for the Mi Series Controllers. Unless otherwise
noted, these specifications apply to Mi Series 4, 6 and 8 Controllers.
Mi Series Product Specifications
Models Available:
Mi Series 4 Audio Controllers
• DAS-M(I)0404(B/S) 4 Source, 4 Zone Controller (black or silver, 120V or 240V)
• DAS-M(I)0406(B/S) 4 Source, 6 Zone Controller (black or silver, 120V or 240V)
• DAS-M(I)0408(B/S) 4 Source, 8 Zone Controller (black or silver, 120V or 240V)
Mi Series 6 Audio Controllers
• DAS-M(I)0604(B/S) 6 Source, 4 Zone Controller (black or silver, 120V or 240V)
• DAS-M(I)0606(B/S) 6 Source, 6 Zone Controller (black or silver, 120V or 240V)
• DAS-M(I)0608(B/S) 6 Source, 8 Zone Controller (black or silver, 120V or 240V)
Mi Series 8 Audio Controllers
• DAS-M(I)0804(B/S) 8 Source, 4 Zone Controller (black or silver, 120V or 240V)
• DAS-M(I)0806(B/S) 8 Source, 6 Zone Controller (black or silver, 120V or 240V)
• DAS-M(I)0808(B/S) 8 Source, 8 Zone Controller (black or silver, 120V or 240V)
Stereo Output:
25 Watts/CH stereo (20Hz to 20Khz @ .1% THD)
Power:
960W max (Actual average usage = 300W)
Zone Support:
• Eight independent Zones (4 X 2 Zone Modules).
• Each Zone is protected thermally.
• Zone grouping.
• Independent Volume, Bass, Treble, Balance and SRS
®
controls in each zone.
Stereo Amplifiers:
• 40 Watts/CH stereo amplifiers (20Hz to 20Khz @ .1% THD).
• Amplifiers are protected from overload and thermal runaway.
SRS/WOW
®
:
Standard SRS/WOW
®
audio enhancement technology by SRS Labs, on all zones.
Note: SRS/WOW is a registered trademark of SRS labs, Inc.
Front Panel Components:
• Navigation Buttons Allow for front panel programming, selection of sources, and tuning AM/FM
radio stations (when Controller is fitted with the optional tuner board). The
same array appears on the Matrix KP-4e navigational keypad.
• IR Receiver This is where you must aim the remotes from your audio source components
so the Controller can learn and emulate those commands.
• LCD Display Displays information necessary during the programming steps and afterward
is the display to indicate information about the source input and zone activity.
Rear Panel Components:
• Power Switch & Receptacle The master power switch will remain in the ON position
normally.
• Paging In/Out Ports RCA jacks to connect to Paging devices (any audio input can be used as a
paging device). The Paging device connects to the Controller via the "Paging
In" connector. The “Paging Out” connector is used to carry the page to Zone
Expander(s).
• RJ 45 Port Ethernet Port for future expansion
• RS-232 Port 9-pin D connector to interface with NetLinx control systems.
• AM/FM Antenna Inputs Connections for the AM and FM Antennas.
• Audio Inputs Stereo Inputs, 47K impedance, buffered.
• Audio Outputs Stereo Looping Outputs, buffered.
• IR Outputs • Mi Series 4 - Four IR 3.5mm mono output jacks.
• Mi Series 6 - Six IR 3.5mm mono output jacks.
• Mi Series 8 - Eight IR 3.5mm mono output jacks.
To Next Page
Loading...
