AMX DAS-M-0404 - Setting System Date; Setting the Day of the Week; Viewing Alarms

Programming
36
Mi Series Audio Controllers
Setting System Date
1.
In the Clock Setup screen (FIG. 23), select MM (month) by using the Navigation buttons (<< / >>)
on the front of the Controller. An arrow is displayed in front of MM.
2. Using the UP/DOWN Navigation buttons, increase/ decrease the month.
3. Proceed to DD (date) & YYYY (year) in the same manner.
Setting the Day of the week
1.
In the Clock Setup screen (FIG. 23), select DDD (day) by using the Navigation buttons (<< / >>) on
the front of the Controller. An arrow is displayed in front of DDD.
2. Using the UP/DOWN Navigation buttons, increase/ decrease the day of the week (MON – SUN).
When finished setting the Time, Date & Day, Exit the screen.
Viewing Alarms
Alarms set at individual keypads can be viewed from the front of the Controller.
1. Select “Alarms” from the Clock Setup Mode screen (FIG. 22).
2. If there are no alarms set for any zone/room, the following will be displayed (FIG. 24).
3. If an alarm has been set for any room/zone, the room number, source number and alarm time are
displayed (FIG. 25):
 “Next” will scroll forward through all set Alarms.
FIG. 24 No Alarms
FIG. 25 Example: Alarm Room 1