AMX DAS-M-0404 - Zone Grouping (Buttons 1 & 2); Group Mode; To Add a Zone to a Group; Group All Zones

Advanced Keypad Controls
50
Mi Series Audio Controllers
Zone Grouping (Buttons 1 & 2)
This feature is specifically designed to accommodate a situation where it is desirable to link a
combination of rooms (zones) to a common source. For example when hosting a party and you wish to
have the common areas all linked to the same audio source. When initially creating a zone group, all
members of the group will have the volume set to the same level. The volume can then be adjusted on an
individual zone basis, by using the Volume UP/DOWN buttons in each zone. Group Volume may be
adjusted at any time.
Group Mode
In this state, zones can be “grouped” together & controlled as a single zone.
To enter GROUP MODE, press buttons 1 & 2 simultaneously (all source LED’s turn ON).
To Add a Zone To a Group
1.
Press buttons 1 & 2 simultaneously (Source LED’s will turn ON).
2. Key in zone # to add to group.
3. Press ENTER (source LED’s turn OFF).
Examples: (From Keypad in Zone 1…):
 Press 1&2 + 2 + ENTER - zone grouping now includes Zone 1 & 2.
 Press 1&2 + 4 + ENTER - zone grouping now includes Zone 1,2 & 4.
Group All Zones
1.
Press buttons 1 & 2 simultaneously - (source LED’s will turn ON).
2. Key in “99”.
3. Press ENTER - (source LED’s turn OFF).
Example:
 Press 1&2 + 99 + ENTER - ALL zones will be grouped.
FIG. 1 Zone Grouping (Buttons 1 & 2)
Zone Grouping buttons
The zone from which zone grouping is being administered, is assumed to be the 1st
zone in the grouping. It should, therefore, not be added to the grouping.