Encoder Configuration Options
33
N1000 Series User Manual
Change Password
To change the N1000 Encoder interface password, enter the current password in the field labeled Old Password, and enter a new
password in the New Password and Confirm Password fields. Click Change PW to accept the new password.
FIG. 28
Change Password
NOTE: This password needs to match N-Able's stored password to allow auto-login using N-Able.
Software Section
The Software section of the Settings page is shown in Figure 29. Options are described in Table 6 .
FIG. 29
Software Section
TABLE 6 Settings Page: Software Section
Option Description
Serial Displays the serial number of the N1000 Encoder.
MAC Address Displays the MAC address of the network interface of the N1000 Encoder.
Firmware Version Displays the date code for the currently running version of the N1000 Encoder internal firmware.
Web Version Displays the date code for the currently running version of the web interface.
Factory Restore Click to restore the device to the original factory settings. This resets everything except the IP address
(including name, stream number, serial settings, etc.).
Reboot Click to reboot the device (does not affect current configuration).
To Next Page
Loading...