SECTION 3 PANEL DESCRIPTION
3-4
No. Panel Marking Explanation of Function
8 Single This sets the sweep mode.
[Single] Executes single sweep.
[Continuous] Executes continuous sweeping.
Press this key after pressing the [Shift] key.
The initial default is continuous sweeping.
9 Recall This executes recall/save.
[Recall] Reads measurement parameters and waveform data
from internal memory or memory card.
[Save] Saves measurement parameters and waveform data to
internal memory or memory card.
10 Measure This menu is for performing the various application measurements
including frequency measurement, noise measurement, adjacent-channel
leakage power measurement, etc.
11 Display This section is for selecting the trace waveform. Normally, in the
frequency domain, up to two trace waveforms can be displayed.
The zero-span (Time Domain) mode is selected simply by pressing the
[Time] key.
[A, B] Displays trace A or B waveform in frequency domain.
[A/B, A/BG] Displays trace A and B waveforms simultaneously, or
displays trace A and BG (background frequency
spectrum including trace A) simultaneously.
[Time] Switches to zero span (Time domain) mode to display
time domain waveforms.
[A/Time] Displays trace A and the time domain waveform
simultaneously.
12 Trig/Gate [Trig/Gate] Sets the sweep-start trigger and gate (to control
waveform-data write timing) functions.
13 Coupled Function This sets the RBW, VBW, sweep time and input attenuator.
To Next Page
Loading...
