SECTION 3 PANEL DESCRIPTION
3-6
No. Panel Marking Explanation of Function
53 Video (Y) This connector output a Y-axis signal that is proportional to the video
detection signal output and is logarithmically compressed at log scale.
54 Composite Out This is the video composite signal output connector.
55 O/I This is the AC line power switch.
56 (Inlet) This is the fused AC power inlet to which the supplied power cord is
connected. It contains two time-lag fuses.
57 (Functional earth Terminal)
This is the terminal that is electrically connected to the chassis of the
equipment.
58 RS-232C This is the RS-232C connector. Connect it to an external system control-
ler or printer, etc.
59 GPIB or This connector is for use with a GPIB or Centornics (Option 10) interface.
Centronics It is connected to an external system controller, or a printer etc.
60 Trig/Gate In (±10 V)This is a input connector for external trigger/gate signal. (If Option 06 is
not attached to, this connector is not provided.)
61 Phone This is a output connector for earphone. (If Option 07 is not attached to,
this connector is not provided.)
62 Sweep (X) This is a output connector for sweep signal (X). (If Option 15 is not at-
tached to, this connector is not provided.)
63 Sweep Status (Z) This is a output connector for sweep status signal (Z). (If Option 15 is not
attached to, this connector is not provided.)
To Next Page
Loading...
