Anyload OCS Series - Zeroing the Scale; Tare In Functionality

7 | ANYLOAD OCS Series Electronic Crane Scale User’s Guide
ZERO
Action
o
To Z
ERO
the scale, press ZERO key on the scale or on remote
controller.
Function
o The scale will set the current load to Z
ERO
as if it has no load on it.
o The ZERO indicator will light on (some models do not
have this zero indicator).
o The weight reading becomes “0”, (or “0.0” or “0.00”, depending on the
resolution).
Condition
o
The scale must not in H
OLD
mode otherwise an error message
will display
.
o
The scale must be stabled otherwise an error message will
display.
o
Current weight reading shall be in M
ANUAL
‐Z
ERO
R
ANGE
otherwise an
error message
will display.
To learn more about Manual‐Zero Range refer to Scale’s Configuration function.
TARE IN
Action
o To T
ARE
I
N
a tare weight into the scale, press the TARE key
on scale or on remote controller (when the scale is in
G
ROSS
M
ODE
).
Function
o The scale will store the tare weight and will shift to N
ET
M
ODE
. All
subsequent readings are deviated from the tare value.