E-ITN 30
Installation and service manual M2019/01a [EN]
5.4. STORAGE
E-ITN 30 is an electrical device and can be stored under these conditions:
• devices must be originally packed by manufacturer and individually stored in antistatic bags
• storage temperature from +10 °C to +30 °C
• relative humidity from 45 % to 75 %
• devices must be stored in clean covered areas without aggressive substances and stored properly to
avoid mechanical damage
5.5. APPLICATION AND DISPOSAL
"This device is subject to a waste management in accordance with local legislation."
5.6. DEFECTS AND THEIR ELIMINATION
Any E-ITN 30 defect should be repaired by manufacturer only.
5.7. WARRANTY
If device is installed and handled according to manufacturer instructions mentioned in Installation and service
manual, manufacturer provide warranty under the valid legislation unless agreed differently.
The warranty is void if device was used contrary to Installation and service manual or damaged:
• during transport or storage by customer or reseller
• when mounted or dismantled to the customer device
• because of improper handling or installation into other device than agreed in manual
• if the product was exposed to different environment than agreed in manual
• if mechanically or in other way damaged by user
17 / 46
To Next Page
Loading...
Need help?
General
