4.
Mixer 1 - Signal from each channel can be sent through this
mixer by raising the corresponding Mixer 1 Channel Fader.
•
This mixer’s Master signal can then be selected as a
source for the Headphones or Speaker outputs,
providing a low-latency direct monitoring signal path.
•
This mixer can also be sent back into the computer as a
separate stereo input available in your DAW.
•
The faders on this mixer affect the fader send signal of
the other Mixers and FX Send when the Pre Fader button
is not engaged.
5.
Mixers 2, 3, 4 - Signal from each channel can be sent
through these mixers by raising the individual Mixer 2, 3, or 4
Channel Fader.
•
This mixer’s Master signal can then be selected as a
source for the Headphones or Speaker outputs providing
a low-latency direct monitoring signal path.
6.
FX Send - Signal from each channel can be sent through
this mixer by raising the individual FX Send Channel Fader.
•
This Mixer is sent back into the computer where it shows up as
an extra stereo input available in your DAW. By using this input on an Aux track that has a Reverb or Delay or other
effects plugin, effects can be applied to a Direct Monitoring situation which would otherwise be completely dry of
effects.
7.
Pre Fader Button
•
When engaged, the channel signal from the mixer 2, 3, or FX Send mixer is sent to that mixer’s Master fader
based only on that mixer’s channel fader level. This signal level is not affected by the position of the Mixer 1
fader (Pre-fader).
•
When not engaged (Post-fader), the channel signal from this mixer will change based on the Mixer 1 fader
position. In other words, moving the Mixer 1 fader on this same channel will alter the signal level going to the
mixer 2, 3 or FX Send mixer master.
8.
Mixer View buttons - View or Hide mixers using this button.
*Mixers are always ACTIVE. A mix will continue working even when hidden.
9.
Channel Fader - Set the level of the channel signal in the mixer master stereo output.
10.
Channel Pan Control - Set the left-right placement of the channel signal in the mixer master stereo output.
Option-click to reset the pan to center (0) or Option+Command-click to set all pans in that mixer to center (0).
11.
Channel Mute button - Cut the signal routing to the mixer stereo output. Command-click to cut all channels
12.
Mix Solo button - Mute all channels that do not have this solo button engaged in this mixer. Command-click to
solo all channels.
To Next Page
Loading...
Need help?
General
