Remote Window
The Remote window provides settings to configure the optional Apogee Control hardware remote control. To open the
Remote window choose Window > Remote, type Command+4, or click on the Remote toolbar button.
The nine buttons in the window - 1-4, A-D and Control Knob - are used
to define the function of corresponding hardware Function buttons.
The following functions are available for all buttons:
None! - When a button is assigned to None, it does nothing.
Mute Panic!- Mute the headphone and Speaker outputs of all connected units.
- Tapping the button again doesn’t un-mute the signal - it must be un-muted in
Symphony Control software, Touch Panel, or the Control hardware remote.
Mute Speakers - Mute the Main speaker output.
Mute Headphones - Mute the Headphone outputs of all connected units.
Mute All Outputs - Mute the Speaker and all Headphone outputs.
Mute Toggle Headphone/Speaker - Toggle between two states:
1.
All Headphone outputs muted and the Speaker output unmuted
2.
All Headphone outputs unmuted and the Speaker output muted.
-
When recording in the same room as speakers, this function provides one button
switching between recording with headphones and listening back over speakers
Dim Speakers - Lower the Speaker output by 15dB.
Dim Headphones - Lower the Headphone outputs of all connected units by 15dB.
Dim All Outputs - Lower the Speaker and all headphone outputs by 15dB.
!!
Mono Speakers - Sum the stereo Speaker output to mono.
Mono Headphones - Sum the Headphone outputs of all connected interfaces to mono.
Mono All Outputs - Dim the Speaker and all Headphone outputs.
Toggle Speaker Sets - Toggle playback between Speaker Sets; when Main Output Format
(Device sidebar) is set to 2 or 3 Speaker Sets.
Select Speaker Set 1 - Selects the first speaker set; when Main Output Format (Device sidebar)
is set to 2 or 3 Speaker Sets.
Select Speaker Set 2 - Selects the second speaker set when Main Output Format (Device
sidebar) is set to 2 or 3 Speaker Sets.
Select Speaker Set 3 - Selects the third speaker set; when Main Output Format (Device sidebar)
is set to 3 Speaker Sets.
Toggle Main Sourc e - Toggles between the two selectable Main Output sources
Set Main Out to Reference Level - Set the Main output level to a predetermined reference level,
from -64 to 0 dB.
To Next Page
Loading...
Need help?
General
