8x8 Analog + 8 AES/Optical IO Module
Provides a total of 16 channels of audio input and output:
-
8 channels of analog input and 8 channels of analog output
-
8 channels of digital input and 8 channels of digital output through either the AES DB25 connector (Yamaha Pin-out
configuration), or Optical ports
To s elec t e i ther Op t ical or AES d ig i tal a ud i o:
1.
Power off the Symphony I/O and disconnect the Thunderbolt cable.
2.
Tog g le t h e DIG I/O button to the desired position
3.
Power the Symphony I/O on and reconnect the Thunderbolt cable.
Optical ports can be configured to use the S/PDIF or ADAT/SMUX protocols.
S/PDIF 44.1 - 192k Sample Rates! - 2 channels of audio in and 2 channels of audio out
ADAT 44.1 - 48k Sample Rates!! - 8 channels of audio in and 8 channels of audio out
SMUX!! 88.2 - 96k Sample Rates!! - 4 channels of audio in and 4 channels of audio provided per port
!!!!!!- 8 channels in and 8 channels out total when using both ports
Digital Coaxial RCA S/PDIF ports are also provided.
-
SPDIF IN replaces a pair of analog or digital audio inputs. Routing of the S/PDIF input is set with the S/PDIF
Replaces drop down menu, found in the Symphony Control Software’s Device Sidebar.
-
SPDIF OUT will duplicate any pair of analog or digital audio outputs. Routing of the S/PDIF Output is set with the S/
PDIF Mirrors drop down menu, found in the Symphony Control Software’s Device Sidebar.
Note: The two variants of the 8x8 card are also compatible:
8x8 + AES only
8x8 + Optical only
To Next Page
Loading...
Need help?
General
