Remove
the nut and
washer.
Among the screw
thread, there is a
at side.
10. Pull the SMA connector through the above mentioned antenna hole. Note
to meet the aforesaid attened side with the antenna hole's at side.
Arrange the at side of the
SMA connector to meet the at
side of the antenna hole.
11. Mount the washer rst and then the nut to the SMA connector. Make sure
the nut is tightened.
Mount the washer and the
nut to the SMA connector.
Tighten the nut.
12. Have the external antenna(s). Screw and tightly fasten the antenna(s) to
the SMA connector.
To Next Page
Loading...
