Arbor Technology FPC-7900 - Page 77

- 65 -
BIOS
Turbo Mode
Only available when Intel Speed Step is Enabled.
Enable /Disable (default) Turbo Mode (requires
EMTTM enabled, unless max turbo ratio is bigger than
16 - SKL AO W/A.
C States
Enable (default) /Disable CPU power management.
Allows CPU to go to C state when it's not 100%
utilized.
Enhanced C-states
Only available when CPU C States is Enabled.
Enable (default)/Disable C1E. When enabled, CPU
will switch to minimum speed when all cores enter
C-State.
Package C State Limit
Only available when CPU C States is Enabled.
Maximum Package C State Limit setting.
Set package C State limit.
► Options: Auto (default, initializes to deepest
available package C state limit),
CPU Default (leaves to factory default value),
C10, C9, C8, C7S, C7, C6, C3, C2, C0/C1