Device reset time-
out
Use this item to set USB mass storage device start unit
command time-out.
► Options available are: 10 sec, 20 sec (default)., 30 sec,
40 sec
Device power-up
delay
Use this item to set maximum time the device will take before
it properly reports itself to the host controller. ‘Auto’ uses
default value: for a root port it is 100 ms, for a hub port the
delay is taken from hub descriptor.
► Options available are:
Auto: Default
Manual: Select Manual you can set value for the
following sub-item: ‘Device Power-up delay in seconds’,
the delay range in from 1 to 40 seconds, in one second
increments.
To Next Page
Loading...
