MAINTENANCE AND CLEANING
To avoid leakage, never over-fill the washer fluid bottle.
When finished adding fluid, there should not be wiper
fluid visible in the Remote Fill Neck or the plastic tube
that fills the bottler.
5. Replace and tighten the Remote Fill Neck cap.
6. Replace the Front Access Panel, and twist both
thumbscrews clockwise to secure the panel.
Seat Belts
To clean dirt or debris from the seat belts, sponge the
straps with mild soap and water.
Do not allow water, cleaners, or fabric to enter a seat
belt mechanism. Failure of the retraction mechanism
may result. If you notice any damage on a seat belt,
contact Arcimoto Technical Support at (541) 780-0032.
l Do not use bleach, dye or household detergents.
l Do not let wet seat belts dry in the sun. Move the
FUVto a shaded area until the belts are totally dry.
l Make sure that seat belts are totally dry before
allowing them to retract.
Interior
Clean with warm water and a soft, clean cloth (flannel or
chamois). If necessary, use a small amount of liquid dish
washing soap.
l Do not use bleach, dye or household detergents.
l Using solvents (including alcohol), bleach, citrus,
naphtha, or silicone-based products or additives on
interior components can cause damage.
l Statically-charged materials can cause damage to
the Display and sensitive internal components.
FUV Owner's Guide - 119
To Next Page
Loading...
