ARCIMOTO FUV - START the FUV

OPERATION
START the FUV
Note that the Motor Off telltale lights for 2-3
seconds after the FUV is turned ON, while the
FUV is electrically prepared for driving. When
this light turns off, the FUV is ready to go.
Make sure that the Direction switch on the right grip is set
to Neutral (see page 32).
1.
Sit down in the FUV, and fasten the front seat
belts.
If the Driver's seat belts are not fastened when
the FUVis powered up, the seat belt Warning
indicator is illuminated on the Display.
NOTE
As a safety feature, both front seat belts must be latched
for the FUV to allow motion.
2.
Set the Direction switch on the right grip to Neutral
(•).
NOTE
As a safety feature, the Direction switch must be
switched from Neutral to Drive (or Reverse) before the
FUV will move.
If the FUV is started with the Direction switch in either
Drive or Reverse, the FUV will not move until the
Direction switch is moved to Neutral then back to Drive
(or Reverse).
FUV Owner's Guide - 85